![]() ![]() Hopefully this will save someone the two hours it took me of digging and searching for a Utility that worked for me. Essentially the command outputs all information for the Device /dev/sdX where X is the drive letter indicated by Linux. Once booted, I fired up the Terminal and proceeded to figure out what the command was to get the required SMART Information.Įventually I received the information I needed. I went the UNetBootin route on Windows 10 and booted from my Storage Server via IPMI. I won’t go into detail how I was able to create a GParted Live USB as its detailed on their page. So how did I do it? It’s simple, GParted and the Command Line. ![]() Okay getting annoyed now, let’s try my HBA in passthrough mode. ![]() How about the SAS Controller, still no go. I figured I’d plug in the drives into a motherboard and off I go. If it displays any errors, then your hard drive might be experiencing some problems and you should consider backing up your data. Notice the Prongs on the end of the Adapter. To display the overall health of the disk, we use the following command: sudo smartctl -H /dev/sda This displays the status of your hard drive. Unfortunately that doesn’t work because the SAS to Sata Adapters doesn’t allow a connection. I came across a unique situation, I needed to verify health of my HGST HUSML4040ASS600 400GB SAS Hard Drives, but how do you do that? I grabbed my USB to SATA adapter and used a Windows Program like HDSentinel or CrystalDiskInfo. Priorities have changed, and when you can sell a parted out server for the cost of a home insulation job or a new heating system, it’s time to do that. I’m in the process of selling a VMware Server Lab build that has outlived it’s usefulness. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |